JBL Tune 500BT headphone travel case - Free 3D Print Model

Search models, users, collections, and posts

DGA3DP

Household>Other House Models

IP Report

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

3.4 h

2 plates

4.9(29)

0.16mm layer, 5 walls, 35% infill PLA WITH JBL LOGO

5.9 h

2 plates

5.0(2)

Open in Bambu Studio

Boost

182

440

583

357

Released

Description

This is remix of my previous case. I changed locking from snap lock to latch lock.
M3x30 screw and nut is fot the lid and latch mechanism.
M3x25 is for lid hinge.
Lid hinge should be tapped M3 thread before assembly. ( It is not necessary, screw shoud tab the thread when is screwed but make this much easier)

Material: PLA, PET-G
Layer high: 0,3 or lower. I changed layer high to 0,15 on hinges only.
Support needed.
Hardware:
1xM3x30mm Socket head screw
2xM3x25mm Socket head screw
1xM3 nylon lock nut

Comment & Rating (56)

@elviajero80

Very nice design and since I didn't have the screws from another file I printed the screws and assembled it with printed screws and it turned out great

The designer has replied

Show original

@DGA3DP

Thank you for sharing your make

@Edisout

share the file for the screw please

@user_2282711261

Super case for my JBL 520BT. I scaled X and Y values to 95% to be able to print it on my A1 Mini and also added the JBL logo in the lid. Everything is very good and the headphones are now super protected on travels. Thank you very much

The designer has replied

Show original

@DGA3DP

You're welcome. Thank you for sharing your make.

@nhanguyen

Can it be used for the A1 Mini? Thank you for sharing 🙇🏻‍♀️

@user_2282711261

Replying to @nhanguyen :

The original print profile does not fit the A1 mini. I had to adjust it. I scaled the X and Y values to 95%. I left the Z value at 100%. Then the whole thing just needs to be rotated 45 degrees so that it fits on the print bed of the A1 mini. I hope the answer helps you

Show original