In Case of Emergency: Gaffa/Duck Tape

As a gift or decoration: adhesive tape holder in emergency design 

• Cool “in case of emergency” Design
• Wall mount for one or two nails/srews
• Door with hinges and magnetic closure
• Lettering on the door with second color directly 3D printable
• Holder for standard 50mm x 50m gaffer's/duck tape

Parts

The following 3D printed elements are included in the set:

• Case
• Door
• Door handle
• Inlay
• Tape holder

Additional Parts 

• 4 x neodym magnet 8 x 2mm
• Duck tape as example 50mm x 5m
• Double-sided adhesive tape: 
  Example: 3M 467MP/468MP- width: 6 - 10mm
• CA Superglue 
• Transparent door window
  Material: PETG, PC, Acryl - strength: ~0,5mm, height: 171mm, width: 141mm
• Two pieces of 3D printing filament 1.75 mm from the roll
   

Assembly instructions

Please watch the YouTube video for the assembly steps.

Rough overview of the steps:

• Attach the adhesive tape holder to the case
• Mount the inlay in the case
• Attach the magnets to the case and door
• Attach the plastic window to the door
• Attach the door handle to the door
• Attach the door to the case

Filament

All parts were printed using PLA material.

Colors:

• red
• black
• white

Optional for support interface layer: PETG

Print Information

• All parts are printed in 0.2 mm layer height. There are exceptions for the following parts:
  • The door is printed in 0.12mm layer height to improve the thread for the door handle
  • The threaded part of the door handle is printed in 0.08mm for a better quality
• Support needed only for small areas on the tape holder mount in the case and the tape holder. You can print it with a single filament and break off the support or you can print it with a support release layer like I do. I print the parts from PLA and the support interface layer with PETG. PETG can be easily detached from PLA. This gives you a nice surface.
• The tape holder was placed on the printing platform in this way for better stability. This prevents the holder from breaking on the case
• Support blockers are attached to the hinges of the case so that the hinges can be printed better.
• Internal Project settings for X1C available. These is the printer I used to print and test the parts.
• The following settings are selected:

  • Quality
    Wall generator
    Wall generator: Arachne

    
    Advanced

    Order of walls: outer/inner

  • Strength
    Walls
    Wall loops: 2
    
    Sparse infill
    Sparse infill desity: 30%
    Sparse infill pattern: Gyroid

  • Support

    Support
    Enable Support: Yes

    Type: Normal

    On build plate only: Yes

    Support/raft base: PLA

    Support/raft interface: PETG

    Top Z distance: 0mm

    Bottom Z distance: 0mm

    Base pattern spacing: 2,5mm

Feel free to take a look at my other makerworld models

Tinker.Fun 3D Models

Examples from my models:

I would be very happy about your support: PayPal me

Tinker.Fun YouTube: https://www.youtube.com/tinkerfun

Tinker.Fun Instagram: https://www.instagram.com/tinker.fun