Search models, users, collections, and posts
Bambu Hotend PTFE Side Guard
Remixed by
IP Report
Print Profile(1)
PETG - No Supports - 0.2mm layer, 3 walls, 12% infill
Designer
38 min
1 plate
Open in Bambu Studio
Boost
21
37
5
0
32
19
Released
Description
My hotend PTFE tube constantly smacks the side when printing toward the back right corner of the build area. So I remixed and reoriented MozerMade's model to get rid of the supports, moved the magnets away from the adjacent wall and widened the magnet holes by 0.1mm. This one fits (3) 10x3mm magnets. Print in at least PETG or ABS.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)