Search models, users, collections, and posts

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 6 walls, 30% infill

2.4 h

1 plate

5.0(14)

Open in Bambu Studio

Boost

107

199

179

Released

Description

Summary

No matter if your house catches fire, or your wife wants you to bring out the garbage at 3am, in emergency cases a flashlight allways comes in handy.
But searching for your flashlight in the dark, can cost you that few seconds, that decide between life and death.
So, be prepared!
With this holder, designed for Maglite, your flashlight is always within reach.

Edit 9.4.2017:
Added a Version with countersunk hole on request for direct mount.

Print Settings

Printer Brand:

RepRap

                                            Printer:                      
fullmetal P3 Steel

Supports:

                                            Resolution:                      
0.2mm

Infill:

30%+

                    
                        Notes:                     This part can be printed in two orientations:

Bottom to the Printplate
or
Back to the Printplate

Although orientation 2 looks amazing while printing, I would recommand the bottom to Printplate orientation, because it needs less retract and should be a little bit stronger, due to layeradhesion.
Printing in this orientation can lead to warping at the front corners if you print without a Brim.

Comment & Rating (15)

@BaschDE

Print Profile

0.2mm layer, 6 walls, 30% infill

First print, fits and holds

Show original

@frankbudgets

Print Profile

0.2mm layer, 6 walls, 30% infill

printed in PLA… it’s been a few weeks, so far so good. the single screw mount could probably use a second screw. I might end up making another one with that it improve strength