Search models, users, collections, and posts
Do Not Push Box
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.4 h
2 plates
Open in Bambu Studio
Boost
5
14
2
0
4
1
Released
Bill of Materials
List other parts
- momentary switch x 1:
- 18650 batteries x 3:
- 12v power supply if not using batteries x 1:
- small amount of 18-20ga wire x 1:
- 12v protection board if using rechargeable batteries x 1:
- charging port for batteries if not already on protection board x 1:
Description
So this came about as a thought of “who can resist pushing a button labeled ”Do not push?"" Thought about what I had laying around in the Lair and decided on this. You will need a 12v source, I chose 18650 batteries, a momentary switch, available on Amazon, power supply if you decide to pass on the battery option and a heap car horn, again Amazon or if you have one lying around. Basic soldering skills are needed.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)