Search models, users, collections, and posts
My Watering Can - Spiral/vase mode
IP Report
Print Profile(1)
0.2mm layer, 1 walls, 0% infill
1.1 h
1 plate
Open in Bambu Studio
Boost
15
18
1
0
35
16
Released
Description
This in my proposition for watering can. It prints fast in Spiral mode. It doesn't have any steep overhangs - so it is perfect for as a test print for PVB filament.
How to print
Just print it in vase mode. Use line width 0.6 or higher (I use 0.8 line with 0.6 nozzle). There are two versions v3 and v4 - the newer is easier to use as it does not spill water from above. It's good to print it slow. Slow printing will help keep it watertight. I recommend PETG (for great layer adhesion) or PVB smoothed with IPA (so You can have semi-transparent watering can)
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (1)