Search models, users, collections, and posts
A1 Mini Handle, Centralised gripp & PTFE guide
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 30% infill, minimal support
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
27
77
12
4
84
71
Released
Description
Loved the centre handle of grip created by Kri, ( https://makerworld.com/en/models/502359-a1-mini-centered-handle-grip#profileId-417579 ) but wanted to have the additional PFTE tube guide to prevent cable tangles during operations
- PTFE tubling has been added in as a rotating part, to allow for any angle of feed for the filament tube. Tolerencing is a bit tight to hold it in place, but can be rotated easily using a small pair of pliers or with the attached PTFE tube guide
- Rotating component is printed as a seperate piece, and can be snap fit in after print is completed
- Support settings for the print have been set to critial only, but have been suplimented by manually painted edges, so overall it uses minimal support
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (12)