Skadis Kitty

Simple Kitty panel and mounting pegs, compatible with Ikea Skadis pegboard

Included are long and short mounting pegs. Long pegs may be used to offset the printed panel from your Skadis, allowing other attachments to still be used. Short pegs hold the printed panel closer to the Skadis, and may not allow other items to be hung from the panel.

Due to the variability in Skadis holes, and 3d printing in general, you may wish to print a few extra pegs. Sometimes one (side) will be too tight for either the Skadis or the printed panel. I use pliers to push in and remove the pegs when needed. Pegs do not need support when printing, but there is a string or two on the underside, usually, that can just be nipped off.

Cat is apx 165mmx135mm square, so should fit on A1 Mini. Using the PEI Hot Plate and no glue, pegs stick well to the plate. But you may want to use a brim on the pegs if using a cold plate or they don't want to stick for you, and /or just print them separately.

This model uses a .16 Layer height and that helped smooth the chamfered face corners. Probably ironing the top layers would make it even cleaner.

Enjoy!