Mickey Lamp

Is that my base?

@steviev

Replying to @user_584785845 :

Yes I only used the base and I had an old lamp shade that I used, not 3D printed,

(Edited)

Replying to @steviev :

It looks awesome 😎. I'm glad you liked my base enough to use it! Xx

@Kirajack

A mega file 🥰 Thanks for this. I made something of my own out of it 🤭

Show original

@user_1070322250

Did you put rhinestones? That looks so awesome.

love how this came out!!! can you share what you used for the actual lighting?

@Kirajack

Replying to @user_1070322250 :

Yes, I have

Show original

@DerBugi

I recolored it myself in Bambu and printed it with AMS on an A1 Mini I set the infill to 30%

Show original

@user_1070322250

looks great-love it

@wessneips

How did you get it in color

Show original

@DerBugi

Replying to @wessneips :

I colored this in Bambu Studio and then printed it with AMS I should still have the file

Show original

Printed ok, I could not get it off randomised seams for some reason but looks ok in pla.

awesome!! we printed this and tried all kinds of lighting sources with no fitting properly. could you please share what light source and brand that you used. thanks SO much!!!

Replying to @user_2326477828 :

I bought the lot as a unit from Ali Express. I had to cut and rejoin the wires to feed through the lamp base as everything is press fitted rather than screwed. I used solder and heat shrink tubing to rejoin. You can pick which plug for your country too. Total cost including shipping was $A11

thanks for replying back so quickly. I did find it on ali express...but the socket is 4cm on ali and the socket hole for the lamp is 2.54cm or 1 inch. so how did you make that work??

@DeMarcTreasures

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

This is one of my favorite Prints!!!

Looks great 😃

Has this print profile got randomised seams?? Bambu Studio says aligned but I am getting blobs externally that sure look like randomised seams on both base and shade. It also shows scarf joints enable so I am lost. I have recalibrated everything and manually calibrated the filament. Started a fresh print but stopped it fairly quickly as the same errors are evident. EDIT, changed seams to back, same, changed infill pattern, same. Pics attached.

(Edited)

@user_2307626424

I got the same thing like that, I change the temp to 195 and it came out perfect

Replying to @user_2307626424 :

Thanks, if I reprint I’ll try that.

@user_4232945427

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

printed very nice thank you would you have a Mickey with colors thanks

@user_3235697676

Print Profile

0.2mm layer, 2 walls, 15% infill

Fabulous, nothing more to say

Show original

love how this came out!! can you list what lighting was used?

(Edited)

@bkt_123

Thank you 🌟

The designer has replied

that's amazing! thank you xx

@user_2023685282

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

(Edited)