King Beaver (NO AMS)

King Beaver

The King of the beavers.

Printed in multiparts - NO AMS needed however you will need to glue the right hand and feet onto the model. I would recommend gluing all parts anyway!

When assembling the model put the black nose and teeth into the belly section before pushing into the body, it is very hard to remove otherwise and will be a struggle to put those parts in after. 

Supports are nessesary for certain areas, so make sure to use tweasers or alike to remove all supports before assembley. The eyebrow holes will have small supports just on the front inside which you will need to remove carefully.

NOT AI, NO AI COLOUR PICS WHICH DISGUISE A POOR DETAILED SINGLE COLOUR PRINT. REAL PRINTED RESULTS!

MOST OF MY MODELS ARE FAN ART RECREATIONS AND ARE FOR PERSONAL USE ONLY  : MY MODELS ARE UNOFFICIAL FAN ART AND ARE NOT AFFILIATED OR ENDORSED BY THIRD PARTY IP HOLDERS

Thankyou to everyone who has rated and boosted my prints, if you like the models and want to continue to support the creation of more please consider boosting, it really does help incentivise the creation of more models for makerworld. 

If you would like to "buy me a coffee" to support the continued creation of fun prints you can do so here;

All of my models posted here are free for you to use commercially for free. I make them as a hobby and a bit of fun, with the points helping supply filament and consumables. All i ask if you wish to support my designs and want to sell them is that you are aware of the IP infringement which apply to some of the models and take appropriate responsibility. Please also boost them as much as you can and help with the points and please correctly attribute the model design to this page in your descriptions etc - Thankyou again everyone!