Window Blind Handle (HD Home Decorations Blinds)

We replaced our bedroom blinds with Home Depot's Home Decorations Cordless Blinds. Our previous blinds had pull handles that kept dirt and oil from our hands off the blinds. The new blinds did not come with pull handles.  This simple easy-to-print handle mounts to the bottom rail of the blinds.  These will fit blinds that have a base rail size of approximately 40mm deep by 33 mm tall (1.6" deep x 1.3" tall). I might consider adding other sizes if you provide me via comments with the exact bottom rail measurement.

I printed with Translucent (Clear) PETG. I printed a few in white PLA but the white of the PLA didn't match the white of the blinds. The white PLA didn't look bad however the Translucent filament looked better. I printed with 4 wall loops for strength.  You can print without supports however supports improve the results. To install simply spread the handle enough to place over the rail then center on the rail.  For blinds 48 inches wide or greater you will want 2 handles: one near each end of the blind.