Nine Men´s Morris Travel Version | Megntic

While working on a custom travel chess set, I took the opportunity to design a matching Nine Men’s Morris travel edition alongside it. 

This compact and magnetic set was created with the same care and attention to detail as the chess version.

The best part is: it's fully magnetic! 

During printing, built-in pauses allow you to insert 4x1.5mm magnets:
https://www.amazon.de/dp/B0DDBSBHKL?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

If you prefer to print the board without magnets, no problem — you can simply remove the pause commands. Additionally, you can delete all the "negative parts" used for the magnet slots from the print profile. In Bambu Studio, go to Object and delete the “Magnet negative parts”, as shown here:

I’ve also created a separate profile for printing the lid on a textured effect plate. Many settings were adjusted for this, but one important note: G-code changes cannot be uploaded with the file.
Please manually adjust your printer’s G-code settings as follows:

;===== for Textured PEI Plate , lower the nozzle as the nozzle was touching topmost of the texture when homing ==

;curr_bed_type={curr_bed_type}

{if curr_bed_type=="Textured PEI Plate"}

G29.1 Z{-0.09} ; for Textured PEI Plate

{endif}

These are the settings that work on my P1S. On my A1, a value of -0.05 was sufficient. I can’t give you an exact value — it depends on your printer.

The lid and board are designed in such a way that the lid fits snugly and securely. Initially, it may feel a bit tight, but after opening and closing it a few times, it should loosen slightly. Again, this can vary depending on your filament and your specific printer settings. I’ve calibrated my filament, and it fits perfectly.

I hope you enjoy this travel Nine Men´s Morris set as much as we did during our vacation — and that your print brings you just as much joy!

Also, be sure to check out my version of the magnetic travel-Chess-Game. You can find it here: Link