Search models, users, collections, and posts
ThirdReality Motion Sensor Corner Mount
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.3 h
1 plate
Open in Bambu Studio
Boost
3
17
0
0
32
20
Released
Description
This is a remix of DorffMeister's corner mount for the ThirdReality Motion Sensor.
Like the original, you use 3M VHB tape or command strips to attach the mount to the wall.
I added the box to insert the motion sensor into instead of using 3M VHB tape to stick the sensor to the back mounting plane.
October 14, 2022 - Updated the design to make the box thicker, corrected the angle on the back plane so it was at 45 degrees.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)