Dry & Dry Lid + Pour Spout

Warning: do not speed up the print. The default profile has a support block going through an overhang in order to avoid supports messing up the threads. Higher speeds could cause layer sag or print failure. 

The spouts and pour cups that exist are great, but I wanted something that stayed with the jug so this was my solution. 

Lid and pour spout for 1 quart / 2 lb jugs of Dry & Dry desiccant, including gasket. Gasket is recommended but not necessary, lid has a better seal without the gasket than the stock lid. 

If you squeeze an empty jug with the stock lid, you'll notice that air escapes. That will not happen with this lid along with the gasket. 

I printed mine in PETG, gasket in TPU. PLA would probably be fine for the lid/spout, but I'd skip the gasket if you don't have TPU. 

This is a remix of one item from Verbatim_T's Dry & Dry Desiccant Funnel + Spout.