Frsky TDMX Case with or without Pin Header

This is a 2 piece snap together case for a Frsky TDMX receiver. The receiver slides into the bottom piece and then a choice of 2 different tops snap onto the bottom and it traps the receiver from moving around. 

The first top just encloses the receiver and the 2cd top adds the option to have the signal wires mount to a 6x3 pin header. This gives you easy setup with power, Sbus in and Sbus out, along with standard 3 pin for the 4 PWM channels. 

This version also secures and protects the delicate 30awg harness.

I included the stl and step files for each. 

The header I used is a TSW-106-07-L-T from Digikey.

I printed the case with Petg using a .2mm nozzle for very small detail for the case lock and the lettering.

Using a .4mm nozzle, I assume you would have to adjust parts of the model for proper fit.  The step files can be modified easily.

I will be filling the backside of the header with hot glue for insulation and securing the header to the case.

I did use a couple drops of CA also.