Cord Stop / Lock - Print in Place - 3D Spring
Print Profile(1)
Description
Boost Me (for free)
Did you know? MakerWorld gives out free Boost tokens to active users! These tokens can be used to support any model you love -- at no cost to you. You may not even know that you have Boost tokens. But they are a big help to creators. Please show your appreciation by boosting the models that you like.
This is a print-in-place cord stop / cord lock for use with paracord, or other types of cord, or elastic.
It is 100% 3D printed, and includes a 3D printed spring. No assembly is required. No hardware is required.
Two versions are included, one that is 18 mm wide, and the other is 16 mm wide.
Both can accommodate two pieces of Type III paracord. The 16 mm version is a little tight, but it works. The tightness actually makes the cord stop hold better.
The total diameter of the cord hole is 6.8 to 7.6 mm, depending which version you use.
Both hold the paracord pretty tightly. But don't trust your life with it.
They should be printed, as oriented in the print profile, with the spring side flat against the build plate.
PETG is strongly recommended. The 3D printed spring probably will not work with PLA, and may break.
Let the part cool completely before pressing the button, and exercising the spring.
Membership
My models are always available for personal use here, for free. But if you would like to sell physical prints of my models, you can do that if you subscribe to my commercial licensing membership. Thanks for your support!
License
Comment & Rating (15)