Search models, users, collections, and posts
BMW Heater Pipe Clamp (OEM 750 256 4) for BMW E46
IP Report
Print Profile(1)
0.16mm layer, 4 walls, 15% infill_TPU
Designer
5 h
1 plate
Open in Bambu Studio
Boost
27
78
2
1
16
3
Released
Description
Replacement part for the heater pipe clamp located under the airbox. Used as a noise reducer, the OE part is made of rubber; mine was broken so I had to design it myself.
Easy install, remove the airbox and simply clip it on the two screws.
Installed on my E46 and tested in real conditions for about 3,000km - it works the same as the original part. Lighter than OEM.
Print with regular TPU 95A at maximum 15% infill so it stays soft, as 95A TPU can be hard when printed at higher infill percentages.
Designed by axwasser
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
Comment & Rating (2)