Poseable Articulated Emperor Penguin No AMS

Articulated Emperor Penguin

The Emperor penguin is the largest penguin and it lives only in the frozen continent of Antarctica.

Because of the number of small parts this is not recommended for small children.

Printing Instructions

All PLA parts have been only tested to print on a Bambu Cool plate and have not been tested on a textured PEI plate due to the large amount of parts with low contact area if you would want to attempt to print on a plate other than a Cool plate please clean your build plate and use brims/ rafts as necessary.

This model can be printed without the use of an AMS system by manually changing the colors by pausing the print at specific layer heights that are shown as layer changes in the print profile.

The ball joint connector parts have only been tested in PETG and it is highly recommended to print them in PETG.

Post Processing and Assembly 

Please wait for the build plate to cool before carefully removing the parts from the build plate.

For post processing the only thing that needs to be done is removing any rafts/ brims that have been used and loosening up the legs wich can be done with a small knife carefully pry the legs free and able to move.