HGLRC Rekon 7 Side plates with camera mount

I wanted to be able to fly this Rekon 7 at night in all weather.  Fitting the AI box of a Caddx Infra was going to be a struggle so I designed this to be able to mount it perfectly behind where the camera would have originally gone.  There's a space underneath with lots of room to mount your RX module at the front as well.  WARNING: the camera mount is 20mm wide for the Infra.  Most full size analog cams are going to be 19mm so you may need an adapter or stack a few washers, easy fix.  My VTX is a Rush Max Solo so it has a built in fan.  If you don't have a fan you could get overheating due to it being covered on 3 sides.  Air can flow front to back but I doubt much gets in.  This was a compromise I had to make to be able to fly in rain.  If you need more cooling, the side plates are thin enough around the VTX that you could easily just cut a few slots with scissors  to get some air flow.  The side plates flex and can be pulled out of the way to access the FC plug.  They can be popped back in place easily enough without having to take anything apart.  The forward oriented GoPro mount is from Thingiverse, it's not my design.  Should be easy enough to find if you want it.  The GPS mount is for an HGLRC M100 but may fit others.  It's a friction fit but I would put double sided tape just to be sure.  I wanted it level with the frame so it was a simpler set-up in iNav with the compass.