SpinePress - For Paraspinal Tension Relief

Targeted Back Pain Relief

Say goodbye to stubborn back tension with the SpinePress, a dual-point muscle relief tool designed to hit those tight paraspinal zones with just the right amount of pressure. Back pain sucks; whatever the cause, this tool's got your back – literally.

***DISCLAIMER: I AM NOT A DOCTOR***

****This device is intended to be used while sitting in a chair so the user can control how much pressure is applied. DO NOT use while driving!! (If you get rear-ended while using this device, it could mess you up worse.****

Key Points:

• Ambidextrous Design

  • Use it any way, either way. Flip it, rotate it – as long as one bump is positioned on each side of your spine, you're good to go.

• Grip Zones 

  • so it's easy to hold and position behind you with one hand.

• Chair-Friendly Base

  • The broad, flat bottom distributes force evenly, preventing damage to your chair while staying stable and effective.

• Scalable

  • Print it as-is, bigger, or smaller to match your body type and pressure preference.

  • See images below for reference of unscaled model:

• MATERIAL:

  • This can be printed in PLA, PETG, ABS, ASA, TPU for AMS, & everything in between… but TPU 95A is my favorite; it's the perfect balance between “OUCH!” and “Aaaah YEAH”.

Feedback is welcome!

ENJOY!!

Out of boosts? You're welcome to “buy me a coffee” if you really like this model & want to fuel my creativity.😉