Floor Mat Holder VW / Seat / Skoda / Audi / VAG

Unfortunately, my original floor mat holder came loose, and since I didn't want to dismantle half the car to reattach the holder from the underside of the carpet, I designed a new holder.

You need the original top part (part number: 8E0864229)!

Due to the high temperatures in the car, please print it at least from PETG or ASA.

The top part is simply pressed onto the printed part (for better hold also some glue, but not necessary). Then push the whole part into the existing hole in the car carpet, put the floor mat on and you're done.

When removing the floor mats, please make sure that this holder can be pulled out again - therefore caution.
But it holds perfectly for normal everyday use!

I designed it for my Skoda Octavia IV, but it should fit in almost any other VAG car.