Desk Paper Organizer

A4 Full Size Portrait Mode V2

At the office or at home, I needed a small shelf to organize A4 or Letter size paper

To find the model I wanted, I looked for various products but couldn't find an organizer or shelf of just the right size

The overall dimensions are as follows

Width : 230mm

Height : 270mm

Depth : 320mm

Gap between sections : 55mm

For 5 sections, print 5 floor panels and 2 side walls for assembly. The back panel can be printed or omitted

No supports are needed and no super glue is required. It's split to be printable on non-H2D series. You can simply snap the parts together

Although it's set to a single color, you can set the color for desired parts

One floor panel layer requires 212g of filament, totaling 1kg for 5 prints

Back 194g + Left 234g + Right 234g = A total of 1,722g of filament is required

Update V2 Profile (portrait priority applied)

From V2, the floor panels have been improved with a cut shape for easier assembly with the side and back panels. It was completed thanks to those who shared many opinions for improvement

Update #1

Added A5 paper size profile. The height has been slightly reduced to 250mm to fit the X1, P1 model bed size

Update #2

Added an A4 paper landscape version profile. The height and spacing have been slightly reduced compared to the existing portrait version

The height is 250mm and the gap between sections has also been reduced to 51mm

…

If you are looking for a stackable single-section version, there is another model available

👉 https://makerworld.com/en/models/1664500-stackable-full-size-paper-tray#profileId-1761298