Search models, users, collections, and posts
Greasing Tongs (for greasing your 3D printer rods)
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
15 min
1 plate
Open in Bambu Studio
Boost
5
27
0
0
34
4
Released
Description
I created these to make it less messy and easier to get in to right spaces where my fingers couldn't fit. They are for adding grease to the solid rods that various parts travel on. My delta printer uses 8mm rods and that's what I designed this for my they'll work for other sizes as well. You could scale them to fit anything you like.
Print Settings
Printer:
Flux 3D Delta
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
20%
Category: 3D Printer AccessoriesLicense
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)