Kobra 2 Neo Timelapse selfie stick switch mount

So, yeah, there are several existing prints for what I wanted to achieve. But I had a spare old cheap wired selfie stick which I wanted to use. This way you can use any old phone (as many new phones, especially iPhones don't have audio jack). Going with wired one helps to keep your phone in flight mode so you don't need to put in charge for the whole print time. It is quite small and fast to print, even easier to mount on the printer. There are two parts

1. The mount, which goes on right side of the x-axis. The button circuit from selfie stick will be in the small grove with some 2 sided tape.
2. The switch, which needs to be stuck with mount using any flexible tape like duct tape. I could have added some hinge mechanism, but I'm yet a newbie in this

This could probably work with all Kobra 2 series (just a guess)

GCode to be added to After Layer change

; --- Retract filament to prevent oozing ---
G91                ; Relative positioning
G1 E-0.8 F2500       ; Retract 
G90                ; Absolute positioning

; --- Move to trigger position ---
G1 X215 Y200 F7200   ; Move to safe position 
G4 S0              ; Wait for move to finish

; --- Trigger camera via limit switch ---
G1 X220 F1000              ; Press limit switch 
;G4 P200            ; Wait 200ms (debounce/delay for camera)
G1 X215 F7200              ; Release switch 
G4 P500            ; Wait 500ms (ensure camera captures)

; --- Re-extrude filament ---
G91                ; Relative positioning
G1 E0.8 F2400      ; Extrude 
G90                ; Absolute positioning