Genshin Impact Furina Wobble Toy
Print Profile(3)
Description
All FDM 3D Printed wobblers, which can bounce around in a car or on a desk
Remodeled a chibi Furina, made into separate parts
3 types of figures--Slime, Fufu lying on a slime, Hu Tao's ghostly spirit
Will update with an Elysia wobbler or other slimes when I have time
Note:
The joints need to be glued
The spring is best made with PETG!! It has higher elasticity and toughness than PLA
Do not print with silk or matte, they are very brittle
---
Also, the base needs magnets. If you don't have magnets, use double-sided tape to stick it
Base magnet specification - round, diameter D6*3MM, 2-4 pieces
2 ways to install the magnets:
1. Force it in firmly
2. After the base is printed, place it back on the heated build plate, heat it to 50-80 degrees for a few minutes, then pick up the base and press the magnets in while it's hot
---
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)