Lathe Carriage Handwheel 14x40 Enco

I broke the original cast iron lathe carriage handwheel from my 1997 enco 111-3320 14x40 lathe and needed a replacement as there was no factory replacement available.

this will fit many lathes of similar era and size, notable the Jet 13 and 14x40 along with many other lathes that all share parts and characteristics.

I had to use a ¼ drill bit to open up the spring/ball holes that retain the indicator wheel after printing but other than that very straight forward. I noticed the main shaft hole on mine was a little tight, so that also could need attention depending on how it prints for you.