Clicgear Replacement Cup Holder - 2 sizes

Replacement Cup holders for the Clicgear golf carts. I mad some for friends with another brand of cart, so adapted that to fit the Clicgear carts as well. Each of them are rather short prints and done at a angle to reduce supports and increase strength. If you think you need more strength you could always add another wall or up the infill some to achieve this.

I do not suggest scaling as the mount will not work. I have designed it to be rather snug as it will work looser in short order.

Only takes 3 - 4 ½ hours to print one but can fit 2 on one plate too if your doing a few to save a little time. 

I tried printing in TPU for AMS but still seemed too flexible but have designed a model that will hold regular can's easy enough and allows for some flex,  and another more rigid version but it looks a bit rough and it doesn't like to do overhangs. Will certainly work in either case though. 

I recommend printing in at least PETG, but ABS or ASA is likely a better choice, and for that there are three other models, one “Normal Size” that is more for tall or regular cans and smaller bottles, and one “Larger” that will accommodate larger drinks, and then a shorter version of the Normal size that is easier to get a normal can out of.

Hopefully you find them useful and they hold up well.

As always if there is something of mine that you like and would like tweaked in someway or perhaps something new created, please send me a message!

As always if there is something of mine that you like and would like tweaked in someway or perhaps something new created, please send me a message!