Marth - ChromaLink

This is designed to use the ChromaLink frame made by Superseaslug. It can be printed on it's own  but it's meant to be hung up using the kit found here.

 The Model is 173.3x200mm in size
You may print at higher layer heights below the Min Depth of 0.16mm
The Max Depth is 2.2mm and the Actual Depth is 2mm

Filaments Used:
    PLA BambuLab Basic Red Transmission Distance: 4
    PLA BambuLab Basic Yellow Transmission Distance: 4.3
    PLA BambuLab Basic Jade White Transmission Distance: 5
    PLA BambuLab Basic Blue Transmission Distance: 4
    PLA BambuLab Basic Black Transmission Distance: 0.6
This print uses 5 unique filaments

Swap Instructions (these are the modified values for ChromaLink. If you are just using the hueforge stl refer to the marth_describe.txt file):
    Start with Black

    At layer #17 (2.96mm) swap to Red
    At layer #22 (3.36mm) swap to Yellow
    At layer #25 (3.6mm) swap to Jade White
    At layer #30 (4.00mm) swap to Blue
    At layer #33 (4.24mm) swap to Black
    At layer #37 (4.56mm) swap to Jade White for the rest.