Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, Supports, 15% infill
Designer
23.3 h
3 plates
Open in Bambu Studio
Boost
14
26
8
1
33
13
Released
Description
Boost Me (for free)
This 3D-printed model of Bugcat Capoo was created using PLA filament with a 0.20mm layer height and 15% infill, incorporating supports to ensure optimal detail and structural integrity. If you find this model appealing or useful, I would greatly appreciate your support through a like or a review. Your feedback not only encourages continued creativity but also helps others discover and enjoy this design. Thank you for your interest and support.
Cute Model of Bugcat Capoo
I printed in PLA
- Infill: 15%
- Layer Height: 0.20mm
- Supports: Yes
If you like my work, please consider liking or leaving a review.
Check out my other models:
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)