Print-in-place watchstrap fidget toy

Print-in-place watchstrap / tambour-door inspired fidget toy.

Once printed:

• loosen up each plate by flexing it back & forth a few times
• carefully snap the two ends together to form a loop (the outer cheeks can snap if you're not careful)
• roll it back wards & forwards between your palms a few times to loosen everything up
• enjoy!

The action frees up the more you use it but still retains a nice feel. I roll them to the print plate impression is on the outside as I like the tactile feel.

I first printed in PLA Matte and then again in PETG - I think the PLA actually has a better ‘feel’…