Search models, users, collections, and posts
Airtag Keychain
IP Report
Print Profile(1)
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
76
195
20
12
341
213
Released
Description
The one in the photo is printed with CF PET-G from Prusa.
When printed, just snap in the Airtag and its held snugly.
Best printed with a 10mm brim with the flat top facing the print bed. When placed like this it doesnt require supports.
Support and Feedback:
If you like the design, you can buy me a coffee here: https://www.buymeacoffee.com/kazikg
Encountered any issues or have suggestions? Feel free to leave a comment below. I'm here to assist and continuously improve this design. Your feedback is invaluable! :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (20)