ALCO Builders Plate Coasters

ALCO Builder Plate Coasters

American Locomotive Company  - Schenectady Works

These coasters are larger than normal coasters and are approximately 146.49mm long by 102.28mm wide and 3mm thick.
 I have put these coasters and the special coaster holders on multible build plates to make it easier to deal with.

I have made available two different coaster holders, one with the logo in it and one that is just plain with no logo.

If you decide to try and print the holder with the builders plate logo, there is a chance that it may not print well.  I had some issues when I tried to print it and that may have been because the humidity has been so high in my house and the possiblity that my silver/gray filament wasn't completely dry when I finally got around to printing it. You may have to mess around with the settings. Your mileage may vary. If it doesn't work for you please don't get upset with me, just print the plain one which prints just fine.

The holders are 24mm high because I used 2mm cork adhesive on the back of the coasters instead of my preferred 1mm cork. If you apply thinner 1mm cork on the coasters than you may want to change the height to 19mm or 20mm.

Take a look at my other railroad and non-railroad coasters and clocks at https://makerworld.com/en/@railimages