Search models, users, collections, and posts
Vesta Quick Weight Horns
IP Report
Print Profile(1)
0.2mm layer, 10 walls, 35% infill
Designer
23.4 h
1 plate
Open in Bambu Studio
Boost
8
34
1
1
20
1
Released
Description
Quick weight horns for Vesta weight stacks (or other 3.5" wide plate stacks).
Here are the magnets I used: https://a.co/d/5uoJxZm
The hole was tapped with a 10-24 tap: https://a.co/d/ggEOsE0
The screws used were flathead 10-24 5/8" L from this set: https://a.co/d/eLcEdSK
As long as your screw fits in the hole though, you should be able to use any metric equivalent. You can also just glue in the magnet if you don't want to go the drill and tap route, I just wanted to be able to swap out the magnets in case i managed to smash them or something.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)