Rubber Track MOD @ NikkiB Ford Super Duty Toy

Some info about the mod:

The outer casing of the console, which holds the rollers, must be installed in the correct orientation. At the top mounting hole, there's a recess for the fixing screw — this should face outward. At the lower pins, the parts are intentionally not fully flush, don’t force them.

Printing the TPU track can be tricky, especially if the filament isn’t dry enough.

There are two versions:

• V1: narrower and slightly more flexible — it might perform better, but this depends on your filament.
• V2: a bit wider and “stiffer”.

For the rear wheels, the narrower version (V1) may be optimal, but both versions actually fit fine.

I also made an adapter for the original tool that came with the model (I haven’t had time to test it yet, but it should work in theory). I personally used a regular Allen key for assembly.

The mounting screw might feel a bit tight going through the bracket at first — that’s intentional.
It will loosen up a bit over time, but I didn’t want it to be too loose from the start.

Rim&Tire MOD @ NikkiB Ford Super Duty Toy

Roll Bar&Lamps MOD @ NikkiB Ford Super Duty Toy

Rubber Track MOD @ NikkiB Ford Super Duty Toy

These mods are designed for:

Ford Super Duty by NikkiB - MakerWorld