X-T5 Thumbgrip

I've wanted to get a thumb grip for my Fujifilm X-T5 for quite a while but purchasing one is usually $30-$50 and I just couldn't justify spending that money when I didn't even know if it was something I'd actually like. I very recently got into 3D modeling and since I wasn't going to be purchasing a thumb grip for my X-T5 anytime soon I decided to just design my own. This thumb grip design went through many iterations but luckily it only costs a little over 3 grams of filament so I wasn't just burning through it. The paddle where your thumb rests has a slight curve to allow for better/more comfortable thumb placement and at the bottom of the paddle there is a slight upward curve so you can still access the dial wheel on the camera. The distance between the hotshoe and thumb paddle leaves enough space to easily see whether “Still” or “Movie” mode is selected and lastly it's a nice snug fit that bottoms out perfectly in the X-T5 Hotshoe. I've printed this in PLA and PLA-CF, both are very robust/strong which was a very important feature to me when designing this; I've stress tested the thumb grip while attached to the camera and it would not break, this stuff is strong.