Search models, users, collections, and posts
Model Ship Waterline Marker
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 5% infill
3.7 h
1 plate
Open in Bambu Studio
Boost
23
53
8
7
74
37
Released
Description
I designed this to add a waterline mark on my ship models. It was printed in PLA with no supports and takes approximately 2.5 hours. The hole for the pencil is 7.54 mm (19/64") and is a press fit if an 6 sided pencil is used. A set screw may be needed if using a round pencil.. The hole for the tightening screw for the vertical height is 5.16 mm (13.64") and I used an M10x20 bolt with a nut and washer. I hope you enjoy the print.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)