Warboss Ork – Hueforge – 6 Colors

This imposing Warboss Ork 3D Hueforge print explodes with brutal energy and grimdark flair, rendered in 6 bold colors for maximum impact.
Perfect for fans of sci-fi battles, fantasy warfare, and gritty warlords, this piece brings chaos and character to any wall.

You can find my other models of the same type on my profile.

https://makerworld.com/en/@3dkmaker

If you are printing on the Bambulab A1, you will need to print the version with the built-in pause and manually change the Black filament to White and Brown to Yellow at that point in the AMS and then you can resume printing.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
You may print at higher layer heights below the Base Thickness of 0.8mm
The Max allowed Thickness is 2.72mm and the Actual Thickness is 2.64mm

Filaments Used:
    PLA PolyLite Black  Transmission Distance: 0.3
    PLA PolyLite Brown  Transmission Distance: 0.8
    PLA Prusament Opal Green  Transmission Distance: 4
    PLA BambuLab Basic Red  Transmission Distance: 4
    PLA BambuLab Basic Yellow  Transmission Distance: 6
    PLA PolyLite White  Transmission Distance: 5
This print uses 6 unique filaments

Swap Instructions:
    Start with Black
    At layer #11 (0.96mm) swap to Brown
    At layer #14 (1.2mm) swap to Opal Green
    At layer #16 (1.36mm) swap to Red
    At layer #21 (1.76mm) swap to Yellow
    At layer #22 (1.84mm) swap to Opal Green
    At layer #26 (2.16mm) swap to White for the rest.

(Swap at pause - Black > White and Brown > Yellow)