University of Louisiana at Lafayette Coaster Set

ULL Coaster set.  The holder is large enough to hold 4 coasters.  Because of the fine lettering on the coaster insert, it must be printed with a 0.2 mm nozzle.  The base and the holder can be printed with a 0.4 or 0.6 nozzle.  The base and holder in the pics were printed with a 0.6 nozzle, and the look fine.  After printing the insert and base, just a a few drops of glue to the base, then pop in the insert into the base.

Important note:  The indicated print time of 8 hours assumes that the base and holder are both printed with the 0.2 mm nozzle, so the 8 hour print time is incorrect.  If the parts are all printed with their recommended nozzles, the print time is 2.5 hours for each coaster, and 1.25 hours for the base and holder, for a total time of 11.25 hours for the full set.