Search models, users, collections, and posts

SD Gundam Ground Type

Print Profile(1)

All
P1S
X1 Carbon
H2D
A1
X1E
P1P
X1
H2D Pro
H2S
P2S
H2C
X2D
A2L

0.12mm layer, 3 walls, 15% infill
0.12mm layer, 3 walls, 15% infill
Designer
7.3 h
4 plates
4.5(2)

Open in Bambu Studio
Boost
110
217
7
5
129
22
Released 

Description

Content has been automatically translated.
Show original

Boost Me (for free)

Give me a boost!!!
Your support fuels my passion!!!

SD Gundam Ground Type GM, featuring articulated leg joints.

 

The Ground Type GM (RGM-79【G】) is a ground combat-specialized mobile suit developed by the Earth Federation Forces during the One Year War (U.C. 0079) in the Japanese anime series *Mobile Suit Gundam*. Based on the RX-79【G】 Ground Type Gundam, the “G” in its designation signifies ground combat adaptability, primarily optimized for ground warfare with enhanced protection and terrain traversal capabilities.

As an emergency mass-production model, the Ground Type GM entered production in July U.C. 0079, with a total of 42 units produced and subsequently deployed to Southeast Asia and the Odessa front for base defense missions. Maintaining parts commonality with the Ground Type Gundam, its design incorporates reinforced armor, goggles-style sensors, and three-segmented articulated feet. Post-war, some decommissioned units were converted by Anaheim Electronics into technology verification platforms, gradually phasing out of frontline service with the proliferation of general-purpose mobile suits.

 

Certain parts and joints utilize components from this series; installation is similar, theoretically allowing for interchangeable combinations. Show your support if you enjoy this model!

https://makerworld.com.cn/zh/models/132062-sd-ji-mu?from=search#profileId-738675

 

Comment & Rating (7)

(0/1000)

Print Profile
0.12mm layer, 3 walls, 15% infill
Nice model, assembled result is about 11cm tall. Some connections need to use glue.
profile
1
Reply
can us A1mini guys get a slice? sick work regardless
The designer has replied
0
Reply
Yes, but you need to set it up yourself
0
Reply
are you able to get instructions?
The designer has replied
0
Reply
Reference photo installation, not difficult to install
0
Reply
not very good needs a lot of glue and pieces don’t fit together well
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
great
0
Reply
No more