Shit Bucket (ORIGINAL) - H2/X1/P1 Series

The original magnetic Shit Bucket and compact poop container that mounts to the chassis with five 10mm x 2mm magnets or four 1/2" x 1/16" OR 13mm x 1.6mm ← SAME THING!!!

WARNING: Sport mode (or slower) is recommended (ludicrous wasn't perfect for me).

Changes:

V4 (9/30/25)

(NEW) Shit Bucket - Recommended Magnets (0.2mm, 72.10g, 1h 35m - sport)

(NEW) Shit Bucket - Common Magnets (0.2mm, 72.17g, 1h 35m - sport)

• Consolidated the three print profiles into two print profiles/models. One model supports a common 10mm x 2mm size magnet, the other supports a larger ~13mm x ~1.6mm magnet. I recommend the latter, as they're significantly stronger, though both are reliable. I've been using the common magnets for years at this point, but I'm swapping to the stronger ones to avoid spilling a bucket full of printer shit.
• Significantly reduced print times while increasing strength and decreasing material use compared to 2/3 of the old models.

V3 (11/19/23)

(NEW) Shit Bucket - Aesthetic (0.20mm, 73g, 3h 42m)

• Uses only necessary internal support
• Decreased filament usage by 16g (when compared to V2)
  • 99g → 73g
• Improved print time by ~21% (based on Standard X1C speed mode)
  • ~4h 40m → 3h 42m (Sport mode = 2h 49m print)

(NEW) Shit Bucket - Fast & Least Material (0.28mm, 71g, 1h 26m)

• Decreased filament usage by 2g (when compared to Shit Bucket - Aesthetic)
• 73g → 71g
• Prints faster than the 0.20mm variant by ~62% (based on Standard X1C speed mode)
  • 3h 45m → 1h 26m (Sport mode = 1h 5m print)

(NEW) Shit Bucket - Strong (0.20mm, 96g, 4h 18m)

• Uses less internal support without sacrificing strength
• Decreased filament usage by 3g (when compared to V2)
  • 99g → 96g
• Improved print time by ~8%
  • 4h 40m → 4h 18m (Sport mode = 3h 22m print)

V2 (?/?/23)

• Added internal supports
• Magnet holes have tighter tolerances
  • 11mm → 10.75mm