Search models, users, collections, and posts
Holder/Charger for SenseCAP T1000-E
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
49 min
1 plate
Open in Bambu Studio
Boost
21
60
7
1
77
70
Released
Description
Boost Me (for free)
If you found this model useful, please consider giving it a boost. It would be very much appreciated <3
A nice little desktop charger/holder for the SenseCAP T1000-e Tracker.
Make sure that the charger is pushed all the way into the cutout. The magnet from the charger should hold the device in place.
Updates:
In v2 I made the bottom shelf extend the full width of the holder. This reduces the chance that the T1000-e will end up sideways.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)