Search models, users, collections, and posts
Blower exhaust duct and quick-release fitting for 50mm pipe
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
0
3
0
0
1
2
Released
Description
Content has been automatically translated.
For Delta BFB1212GH 12v blower, fixed to the board, includes air duct, 50mm pipe, and pipe quick-release fitting.
There is a gap in the quick-release fitting, so it will wobble. The design included a 0.5mm sealing gasket, but I didn't install it...because the TPU filament hasn't arrived yet....
The interface can be sealed with glue or a rubber gasket....In fact, as long as your board is flat, you can seal it without installing anything!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)