Doll headphones plain and Cat Ears
Print Profile(1)
Description
(Who else remembers the Axent Wear headphones..?)
Headphones intended for SD sized BJDs/dolls, or other miniatures.
Please measure your dolls head and compare to the model to ensure fit. But scaling should be fine!
A suggestion is to glue a foam-strip or some fabric to the headband, either for the look or to raise the headphones higher up, should you want to.
Sanding will likely be required. - Depending on your support settings and filament.
And again, depending on the filament, you might want to change/increase the infill or add more wall-loops to make them sturdier.
They are intended to just slide onto the dolls head. They will snap if bent/pulled at.
Printed in PLA Matte.
I used 80 grit and then 800 grit for wet sanding, and it proved quick and easy enough.
Polished with a generic car wax-and-polish.
Or you can skip the polish right to applying some shiny spray varnish.
You can find my other version that has separated parts HERE
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (11)