Viture Dock Pro Switch 2 Attachment

This is my first design/first share.   It is a Viture Dock Pro holder for attaching to the Switch 2.  I used the Legion Go Viture Dock mount from @Kinimodos that I found on Printables, and remodeled the Legion Go attachment to work on the Switch 2.

The fit is tight, but it will still slide a little from side to side until you plug a USB into the top or bottom of the Switch 2.   There is a thumb tab to gently put it on and take it off the Switch 2 (like I said, it is pretty tight).  I am using PLA and so far seen no evidence it is scratching the Switch (YMMV).

Printing wasn't too challenging.  I printed it vertically with a few supports.  Supports should not be needed for the holes for the vents and USB ports, just the overhangs.  I tried at a 45 degree angle which would eliminate some of the supports, but I had quality issues.

It is worth noting about the Switch 2 that when you plug the Viture dock into the bottom, even if it is just to charge, the switch enters dock mode, which turns off the sceen and turns off the ability to use the Joycons attached.   That means two things.  1) if you just want to use the Viture battery to charge, turn the battery upside down and plug the cable into the top of the Switch (Like I have shown in one of the pictures).  And 2) if you want to plug in your XR glasses and hold the Switch in handheld mode, it will not work since the Joycons are diabled.   So basically you have to lay this on a table and detach the Joycons, or use an external controller.