Enclosure Air Quality VOC Display

Enclosure Air Quality VOC Display

With a 1.28-inch TFT display module 1.28 inch (37.8mm)

P1S printer, PLA material, 0.4 mm nozzle, 0.20 standard layer height, Arachne wall generator, no supports

The enclosure can be printed in two versions.
1. An enclosure with a 45° angle.
2. An enclosure at a 90° angle.

The brackets are screwed to the back panel. Apply a little adhesive to the sides (Figure 9) and place them on the enclosure. After the drying time, the lid can be unscrewed again.

The components I used:
1.28-inch TFT display module GC9A01 240x240
ESP32-S2mini processor
CCS811 VOC CO2 sensor
GY-21_HTU21_Humidity_and_Temperature sensor

Round display module
VOC display
Air quality
Housing
ESP32
CCS811 sensor
GY-21_HTU21 sensor
VOC
CO2
Humidity
Temperature