Miniature Toxic Gas Incense/Aromatherapy Box, Separately Printed
Print Profile(2)
Description
Referencing the toxic gas model posted by @GLB_etd_figurine, this design has been modified into an aromatherapy box.
This model is characterized by its lightweight finished parts, as shown in the size comparison image.
The model itself is already pre-separated into parts, only the eyes need to be printed using AMS, and only 10 material changes are needed.
It is recommended to print all models at a layer height of 0.12mm, resulting in a refined model.
Box Structure Introduction
1. Upper body, mainly with air holes drilled through for airflow when incense is lit.
2. Lower body, hollowed out to support a 70mm diameter incense burner, with ash falling into the lower body container.
3. Base, tightly connected to the lower body.
Additional Accessories Needed
1. Incense burner, 70mm diameter, used for placing incense; online purchase cost is around 3 yuan/piece.
2. Four 4*2mm round magnets, used for positioning when closing the lid; pay attention to polarity during installation. Can be omitted without affecting functionality.
Incense burner image below, diameter 70mm
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)