Apple Watch charging stand

Apple Watch charging stand

This is a charging stand for an Apple Watch. In this case, the Apple Watch Series 10 with a 46mm case was used, but all other Apple Watches should also work. The Apple-brand wireless charger fits perfectly into the designated hole without needing to be glued in place. There is a recess at the bottom that fits the case of the AirPods Pro 2. I have also uploaded a version without the AirPods Pro 2 storage.

Important! I recommend very high print quality with the smallest nozzle possible. Only then can good results be expected. Also, only then will the fit for the round Apple wireless charger be correct. The print orientation is also crucial. I printed the hole vertically; the diameter may not fit if printed horizontally!

The model consists of two parts that are later inserted into each other. In my case, both parts held together very well without any glue. However, I strongly recommend manually adding supports for printing the upper part, as I did in my print profile.

I also manually adjusted the vertical seam. Bambu Studio creates the vertical seam directly in the visible area, so I changed its position, see image:

Please also note that with my chosen printing method, 100% perfect results cannot be achieved in the shown area. This is not relevant to me as this side is against a wall anyway.

Enjoy!