Vail VR knife V1

if this model gets to 20 boosts i will make a v2 with ams options and feedback from reviews

After trying to print CSL275's original model i ran into many issues which have been fixed in this remix.

Improvements on CSL275's model:(These took forever because when i made this i was new to 3d modeling)

1. in the original model there was no insert for the blade to go into the handle which created a massive weak spot.

   I improved this by creating an extension on the blade that goes into the handle to better secure it.(this took hours to get the tolerances right)

2. the handle was in one piece

   as much as i would like it in one piece there is two many details on both sides and if i tried to print it as one then this would compromise the detail of one of the sides as i would have to remove all the detail or generate supports which wouldn't look good so i have split it in two.

3. grip and thumb rest

   the grip was a cylinder running down the hand but it was to small so the side were poking into your hands so i made it bigger so it is more comfortable to hold and i added the thumb rest that wasn't even on the model but is in the game.

 Assembly 

this will need to be glued together ideally with superglue or 3d print glue

(be careful not to add to much or it will drip out the sides) 

i have printed the blade in pla silk + silver and the handle in basic pla dark grey

This is one of my first models and i am relatively new to 3d printing so if you have ANY feedback on the model profile ect PLEASE put it because i want to learn how i can improve.