Search models, users, collections, and posts
Sennheiser MOMENTUM TrueWireless 4 - Skadis Holder
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
49 min
1 plate
Open in Bambu Studio
Boost
4
7
3
0
18
9
Released
Bill of Materials
Bambu Filaments
Select all
Description
An adaptation of a simple Skadis holder for Sennheiser Momentum Truewireless 4 found on printable.com.
The original bracket was designed for the second generation, for the fourth generation of the earplugs only the width had to be painted by 4mm.
In the original, the Skadis hooks were not quite attached in the middle, I also corrected this.
Due to the vertical alignment of printing, you get a visually very appealing surface, in my case with Bambulab Pla Matt.
In addition, the stability of the Skadis hooks is best.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)