Print Profile(4)
Description
My take on Thor's Mjolnir Fridge/Office Magnet.
2 versions:
The quick version is one piece, printed straight up and down, with the top of the hammer is the magnetic surface.
The angled/embedded version printed in 2 pieces, head and hammer, with the angled 45 degree surface being the magnetic one.
It uses 2 8mmx2mm magnets that are about 25 layers into the print, with a programmed stop to insert them.
CAUTION: The longer you leave it paused, the more likely you are to get a layer line there.
The head of the hammer is pretty acurate to the original movie prop size, obviously scaled down small enough to make sense as a fridge or office magnet. I did thicken the handle from the movie accurate dimensions, because at the smaller size it looked a bit silly.
I did go all out and have a design with a more accurate handle with the curved breaks in the “leather” but it took the print time from 90 min to 11 hours, which I doubt many people are going to do just to hold up some papers.
For my prints I used eSun Silver and Sunlu Coffee Brown PLA.
Boost Me (for free)
Boosts are always appreciated. Don't let them expire!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (39)